Sunday, May 15, 2011

Reaper's Labella Demornay - 2105



Another rainy day, another figure! An opportunity to sit down for a few hours and crank out this wonderful sculpt. I've had this one sitting on the shelf for awhile (ok - I have a lot sitting on the shelf for awhile primed and ready to go) and it struck my fancy.

I originally had worked up a purple/pink paint scheme in my mind but I changed it at the last second to use a base of Terracotta and work that up to a mix of Terracotta and Skull White - the end result is more of a deep and dirty pink. I've improved my wet palette setup and that really helped - not only to get the flow of the paints and brush, but also the speed at which I can put down layers has dramatically increased. Here's a picture of the new setup:



What I've used is the plastic tray from a Reaper Miniatures blister pack. I chose this for it's size and that it's square in depth (the GW plastic is sloped on their blister packs). The "sponge" is from a GW blister pack - it is exactly the perfect size to fit inside the Reaper blister pack flat. Then I cut a piece of Wilton parchment paper (which I stole from my wife's kitchen) to fit neatly over the top of the sponge. Wet the sponge and wet the parchment paper on both sides and walla... an easy to create and use wet palette that keeps the paint thin for hours.

What I did was put a couple dabs of Terracotta (shade) on one side and a bit of Terracotta and Skull White mixed (highlight) on the other. Then I brought them together in a mix and blended the two colors so I had my entire spectrum of shade through highlights. The wet palette kept the colors in a prepped state for hours. From there I was able to paint. This is a thousand times easier than trying to mix into the white plastic tray the various colors and have them dry out after 10 minutes.

When I'm finished painting, I throw out the parchment paper and wring the sponge out to let dry. Simple cleanup. I suppose it would be easy enough to make a couple of these wet palettes in the case you wanted to hold different colors for a complex or large piece. I found the single palette had enough room (it's about 3" x 2") for everything used on this project. I haven't tried to save the paint overnight but I'm guessing a bit of plastic wrap over the top would do the trick.

Painting Instructions for Labella Demornay:

Step 01: Undercoat model with black primer
Step 02: Use Terracotta as base coat on dress
Step 03: Wash dress with 50/50 mix of water and Devlan Mud
Step 04: Layer Terracotta up to a 50/50 mix of Terracotta and Skull White
Step 05: Use 50/50 mix of Bronzed Flesh and Pallid Flesh on hands and face
Step 06: Wash hands and face with Devlan Mud
Step 07: Add more Pallid Flesh to mix and highlight hands and face
Step 08: Use Scorched Brown on hair
Step 09: Use Bestial Brown on hair
Step 10: Use Bubonic Brown on hair
Step 11: Use 50/50 mix of Bubonic Brown and Skull White on hair
Step 12: Use Shining Gold on necklace and belt
Step 13: Drybrush Codex Grey on stone base
Step 14: Drybrush Fortress Grey on stone base
Step 15: Drybrush Skull White on stone base