This 3d printed dice tower comes from txarlifactory - by height, this is the largest 3d print I can place onto the Bambu Labs A1 Mini - 180cm.
The last picture is the 3d print just about complete - I think it was about 95% at that point. As its purpose is of a dice tower, I printed with the standard .4mm nozzle with standard print settings. Even then, the print was about 9-1/2 hours.
Once printed, I grabbed the airbrush and used the silver balled needle (.7mm) which is great for priming and gave it about two to three coats with a grey primer which concealed most of the layer lines. I then swapped out the silver for the blue needle (.5mm) and sprayed the statue with Vallejo' Stonewall Grey before hitting the mountain with Black. Next up was a lot of drybrushing with the Citadel Scenery Brush - Neutral Grey and then Stonewall Grey on the mountain followed by Reaper's Maggot White (it's just a bit of an off-white as pure white would have been too much) on the statue itself.
To give it scale I took all the pictures on the 3d printer bed including one with a bunch of recently painted models along with some dice.
No comments:
Post a Comment