Today was determining fit and finish and stackability. The 3d print comes with a quarter wall - print four quarter walls and you have a complete ring. Each quarter sits on a pyramidal peg which actually sets very well. However, I figured that you needed to use the dragon locks at the bottom (there's 3 slots) which cinches in the sides together tightly - else it it'll have a gap. While the tower was designed with only a couple of levels if you use the included stair - I needed more levels for the module I was going to run and the party was going to be magically teleported, so I asked my buddy to actually fill in the center hole.
No comments:
Post a Comment